In Force mode, CP Series will force to use reflective sensor to detect label and ignore

commands. It is useful in multi column label.

 

Setting to Force Mode:

1)Open the Model

2)Press FEED key about 5 seconds until POWER and READY are blinking alternately. Then, stop press FEED key.

3)Waiting for READY LED blinking again, then close the printer module.

Leaving Force Mode (switch sensor to see-through)

1)Open printer module

2)Press FEED key about 5 seconds until POWER and READY LED blinking at same time. Then, stop press FEED key.

3)Waiting for READY LED blinking again, then close the printer module.